cast composite garden bench repairs

How to a Wood and Cast Iron Garden Bench - Dengarden

I have a bench made of cast iron and oak by Parkland Heritage - unlike the photo mine has cast iron pieces in the back. But I'll give you the dimensions of mine in case it's close to yours. The wood slats for the seat are 48" (4 feet) long x 2½" wide x ¾" thick, with a support strap measuring 13/16 wide x 1/16 thick running under the seat.

Get Price

How to Replace Garden Bench Slats • Roots & Wings Furniture LLC

I actually googled “garden bench replacement slats” thinking I could just buy some new slats. Harder to find than you may think. But when I took a look at what we were dealing with, it seemed this was a perfect DIY project! Our bench was rotten, the boards, the screws, the whole thing was a mess. So we took it all apart.

Get Price

Restoring a Garden Bench – WoodBin

d garden bench about to leave the shop As far as restoring the cast iron pieces, this was mostly a matter of scrubbing off dirt and bird poop with soapy water followed by a couple coats of Rust-oleum flat black paint.

Get Price

How to a garden bench | Real Homes

The Edwardian cast iron and wood garden bench we are restoring in the step-by-step guide below had been ignored for far too long. Sitting in obscurity at the end of the garden, it was covered in fallen leaves, moss and algae and some of the wooden slats were rotted beyond salvation.

Get Price

How To: Bench Repair using Seven Trust Composite lumber - YouTube

Slightly more in depth than my usual "How To general overviews "made typically nearer to post-production than the actual production is this one on a decorat.

Get Price

How to Replace Wood on Cast Iron Bench | Hunker

Stylish and sturdy, cast iron benches with wooden slats are long lasting components in the backyard garden or patio. These benches are available for purchase through city auctions because of city renovations or at lawn and garden stores. The type of bench bought second-hand may need repairs to the wooden slats because of chipping, splitting or .

Get Price

Restoring an Old Park Bench : 3 Steps - Instructables

For this I laid the back of the bench on some packing paper and traced out the design with a pencil. I then cut this design on the board with a jigsaw and attempted to fit it to the cast iron. It didn't fit precisely so I had to go back and forth from the bench to the jigsaw until the board fit to the cast iron like a glove.

Get Price

Product Details

Product List