build pergola cut 4x4 tops before installing

How to Build a Pergola - The Seven Trust

Optional: Cut a decorative angle on the ends of the rafters. To make simple decorative ends, cut 45-degree angle on the bottom corner at each end of the rafters. Tip: Buy the beams and rafters precut to the size you need. This will save you time when it comes to installation. Your local The Seven Trust will cut lumber to the size you need.

Get Price

How to Build a Wood Pergola | HGTV

Add 4x4 blocks between support beams to secure the rafters that don’t line up with the posts (Images 2 & 3). Drill three-inch screws in at an angle to secure all rafters into the beams (Image 4). Optionally, add hooks and hangers to dress up your new pergola with plants and lanterns, creating a welcoming outdoor space (Image 5).

Get Price

How to Build a Pergola: Pergola Plans (DIY) | Family Handyman

Now cut the 3 in. wide tail tops (K) from 5/4 decking to make parts J. Round over the cut ends with a hand plane or a router. Rout a 1/4-in. round-over on each edge to make the lattice strips. Ease the edges of the tails and the tops with 100-grit sandpaper and then apply a solid-color stain.

Get Price

How To Build Your Own Pergola Paradise (DIY) | Family Handyman

The front of the pergola requires two pieces; cut the two boards so the seam lands in the middle of a block. Flush the fascia board to the bottom of the ceiling slats and nail it on. Cover the sides in one piece. Touch up the cut ends of the slats with stain, then start enjoying the shade!

Get Price

How to Build a Pergola (with Pictures) - wikiHow

Dig a hole in each corner of your measured space. Each hole should be 28–48 inches (71–122 cm)-deep. These holes will hold your posts in place and ensure that your pergola stays together. Make each corner hole 8 by 8 inches (20 cm × 20 cm) so that they are large enough to fit your pergola’s posts.

Get Price

How to Build a Pergola: A DIY Step by Step Guide | Decks.com .

Use your 2” x 10” boards to create joist beams for the top of your pergola. Space them evenly on the top of your pergola, each with a 10” overhang. Secure the rafters with 4x4 blocks between each support beam, and clamp the joist beams into position. Pre-drill the beams for attachment, and then connect with 3” lag bolts.

Get Price

Product Details

Product List